AWD - Setting CD Changer angle as part of installing.
                    

Volvo AWD S70 Forum

INDEX FOR 11/2009(CURRENT) INDEX FOR 6/2009 S70 INDEX INDEX (NO RELOAD) [<<]  [>>]

 VIEW    READ ONLY Replies to this message will be emailed.    PRINT   SAVE   A    A 

Setting CD Changer angle as part of installing. S70 1998

My Cd Changer install project has gone OK. Before I bolt it up in place, I noticed a small plate on one side that had a series of holes in the side going from 0 to 90 degrees. I dimly remember something about adjusting the angle of install depending if the deck was installed facing up or out or at some angle in between.

There is also a single screw holding the plate with all the hose into the case.

How do I set this?

Regards

Woody




Select, copy to buffer, and paste anywhere:


[about brickboard ads]


<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2007. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts