AWD - Setting CD Changer angle as part of installing.
                    

Volvo AWD S70 Forum

INDEX FOR 11/2009(CURRENT) INDEX FOR 6/2009 S70 INDEX INDEX (NO RELOAD) [<<]  [>>]

THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD



  READ ONLY Replies to this message will be emailed.    PRINT   SAVE 

Setting CD Changer angle as part of installing. S70 1998

My Cd Changer install project has gone OK. Before I bolt it up in place, I noticed a small plate on one side that had a series of holes in the side going from 0 to 90 degrees. I dimly remember something about adjusting the angle of install depending if the deck was installed facing up or out or at some angle in between.

There is also a single screw holding the plate with all the hose into the case.

How do I set this?

Regards

Woody




Select, copy to buffer, and paste anywhere:


[about brickboard ads]


[about brickboard ads]

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2007. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts