BrickBoard Archives
The files contained in this listing have been automatically archived from the active forums. Because the vast majority of posts are now in one place, this archive is considered legacy. You should use the SEARCH feature OR choose your topic and select date tabs within the forum you choose.
How to replace light in radio[850/94] posted by Bruce Englar on
Wednesday, 10 October 2001, at 1:22 a.m.
One or more light bulb in the radio doesn't work.
Wife complains that she can't see the radio at night.
Hubby gots to fix it.
Yeah, this sounds like one of those nightmare scenarios...
I've got the radio code. I pulled out the radio (cute mechanism).
Looked all over it. Saw *NNNNOTHING* that looked like a safe way in.
As we all know, Volvo electronics are expensive so nobody wants to break them unnecessarily.
Anybody else been silly enough to change the radio light before? Can you give me pointers? Please?
TIA.
-- Bruce
Bruce Englar
Re: How to replace light in radio[850/94] posted by WatsonMD on
Wednesday, 10 October 2001, at 6:45 a.m.
Bruce,
It is fairly easy and to boot - cheap. A new reconditioned radio will cost $400.
What to do: Go to Radio Shack and buy the micro lamp type 7219 (SN 272-1092C), 2 bulbs per package at about $1.50.
There were 6 lights in my SC-816 (3 lights are shared between the 1-6 radio buttons) To access the bulbs:
1. Pull the radio partially out of the dash (unhook the wiring). Take inside to a well lit area. Remove the screws just behind the face plate on both sides of the radio chassis (4 screws total).
2. Remove the equalizer, fade buttons and tuning/volume buttons, they should pull right off. (don't loose these, as the tend to "pop" off and land in hard to reach places)
3. Pry the plastic retainers just behind the face plate of the radio on the top and bottom of the radio chassis and then remove the face plate.
At this point, you will see a printed circiut board which houses the 6 lights we're trying to get at.
4. Remove the 3 screws the retain the circuit board, these should be at the lower center and upper corners of the board.
5. Carefully remove the circuit board from the radio chassis and pull straight forward. The circuit board is modular and slides into a couple of multi-pin connections, so be sure not to damage. If you have difficulty removing this, try prying gently with a small putty knife.
6. With the circuit board removed, access the lights from the backside by turning the lights 1/4 turn CCW. (you can used a small screwdriver, but you should be able to turn with your fingers)
7.After removing the bulbs from your radio, remove the old bulb elements from the plastic housing and insert the new bulb in it's place. This is tedious. Try to find the end of the wire and pull up on it. Or chip away the "glue" holding to wire leads in place and wrap the new wire leads in similar fashion. However, I was able to do this with just an exacto knife (be very careful PLEASE).
In a hour or so I had replaced all of my bulbs and should be good for another 50K miles. Please note that many owners (including myself) leave their headlights on all of the time, which probably causes the bulbs to burn-out sooner. I now keep the dash lighting at 1/2 brightness.
To reassemble your radio, follow these steps in reverse, noting that the circuit board must line-up with the multi-pin connections and a couple of guide pins. As for replacing the lights themselves, follow the instructions in my previous post.
Best of Luck
Andrew T. Watson
'97 854 GLT, '96 Toyota 4-Runner