Re: Going from old York to new rotary[200/1983]

BrickBoard Archives

The files contained in this listing have been automatically archived from the active forums. Because the vast majority of posts are now in one place, this archive is considered legacy. You should use the SEARCH feature OR choose your topic and select date tabs within the forum you choose.

Re: Going from old York to new rotary[200/1983] posted by BC on
Wednesday, 20 June 2001, at 10:07 a.m.

Bob -

Your suggestion implies that the new p/s pump with separate reservoir will bolt right up to the old rack. True? How about the compressor holder plate? The York has that 20-pound wrap-around thing, does the mount for the rotary just bolt into the old holes on the block? Is there a problem with drive pulley alignment between crank and a/c pulley?

I've though about this but had concluded that things would not fit, perhaps in error.

Thanks for any info.

Regards,

Bob

PS I got the cat-back 2.24 exhaust system for my N/A 1986, but the local floods have slowed the process - I have to rent a trailer to go get the thing as it's a welded-up unit. !

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.