BrickBoard Archives
The files contained in this listing have been automatically archived from the active forums. Because the vast majority of posts are now in one place, this archive is considered legacy. You should use the SEARCH feature OR choose your topic and select date tabs within the forum you choose.
Electric window switch[850/96] posted by Geo Richards on
Tuesday, 23 January 2001, at 9:41 p.m.
I need to replace the electric window switch in my 96 855T. I think it's all one switch, with the four windows and two mirrors on it. Can anyone tell me how it comes out of the console? Thanks.
Re: Electric window switch[850/96] posted by bob on
Tuesday, 23 January 2001, at 10:29 p.m.
The console has to come out. Remove cover in bottom of compartment under armrest, and 2 screws under the cover. The panel with the cig lighter has to come out. Remove the lighter. There are two screws through the panel into the console. They go from front to rear. 1 by the lighter, 1 on right. Remove the coin holder by grabing from the front side and lift. Now lift the panel with the lighter socket from the back side and pull upward and rearward. Slide the diagnostic conector (under coin holder) to the left and remove from panel, un plug the lighter wires and light. Unplug the two elec conectors under the lighter panel. There are two more screws below the lighter panel to the sides of the conectors. (torx 10 or 15) remove these, set emergency brake, pop the trim piece off under E-brake handle, Take shifter out of park, lift the console up from the back side, move it up and back, lifting over shifter and brake handle. Turn console over, remove three retainers for window switch wires, cut cable tie, unplug the auto down relay clipped to the bottom of the console, push switch assy up from the bottom and fish the harness and switch out of the console. It's a tight fit. Reverse procedure to install
--bob