Re: flywheel positioning[700/89]

BrickBoard Archives

The files contained in this listing have been automatically archived from the active forums. Because the vast majority of posts are now in one place, this archive is considered legacy. You should use the SEARCH feature OR choose your topic and select date tabs within the forum you choose.

Re: flywheel positioning[700/89] posted by abe crombie on
Friday, 11 February 2000, at 6:39 p.m.

If you set the front crank pulley to the TDC position per marks on damper and lower belt cover then the flywheel should be installed to have the missing space on aperture ring aligned with hole for starter. The two rivet like pins that face forward will be positioned one above the dowel on block on right side (exh side) and the other below dowel. The flywheel may even have an arrow on it that should point at the flywheel sensor.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.