A1 code 3-2-2 ??[850/94]

BrickBoard Archives

The files contained in this listing have been automatically archived from the active forums. Because the vast majority of posts are now in one place, this archive is considered legacy. You should use the SEARCH feature OR choose your topic and select date tabs within the forum you choose.

A1 code 3-2-2 ??[850/94] posted by sniper on
Sunday, 3 December 2000, at 9:24 a.m.

I have a code A1 (trans) code 3-2-2,,I know my tranny is hurting,does this verify it?

Re: A1 code 3-2-2 ??[850/94] posted by Rich K. Fairfax, VA on
Sunday, 3 December 2000, at 9:54 a.m.

Code A1 322 is incorrect gear ratio

The control module calculates the ratio between the trans input and the car speed, if the TCM registers a ratio deviation of more than 10% DTC 322 is set. causes could be

interference with the signal from the transmission RPM sensor

Contact resistance in the S1 or S2 solenoid circuits

PNP sensor incorrectly adjucted

PNP malfunction

Transmission oil too low

Mechanicial fault in the transmission, worn parts causing slippage or reduced pressure in the system. --
Rich K.
Volvospeed.com/bay13

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.