Re: Removing the gear shift knob on an M46 4spd[200/1979]

BrickBoard Archives

The files contained in this listing have been automatically archived from the active forums. Because the vast majority of posts are now in one place, this archive is considered legacy. You should use the SEARCH feature OR choose your topic and select date tabs within the forum you choose.

Re: Removing the gear shift knob on an M46 4spd[200/1979] posted by Duane on
Sunday, 10 October 1999, at 5:53 p.m.

David was correct. Use a wrench that is slightly larger than the size of the metal shaft. Place it below the knob and with any hammer drive the knob upwards and off the shaft.

Remove the switch and cover for the switch before doing this though.

Duane
83 245 LH 2.0 M46 186xxx
85 245 LH 2.2 AW70 131xxx
Overland Park, Kansas
The OD Guru (Laycock only)

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.