BrickBoard Archives
The files contained in this listing have been automatically archived from the active forums. Because the vast majority of posts are now in one place, this archive is considered legacy. You should use the SEARCH feature OR choose your topic and select date tabs within the forum you choose.
Re: Changing the support bearing and rear transmission seal[200/85] posted by Neal on
Thursday, 3 June 1999, at 1:29 p.m.
I'd add that if you can get the seal and the bushing out without removing the housing, do it. I did this job about 2 weeks ago ( thanks to the archived message mentioned previously, it was on the money). The job went smoothly until I had to remove the old gasket. It was stuck on the trans and took me HOURS to get that sucker off. You might me luckier.
Neal
--Neal