BrickBoard Archives
The files contained in this listing have been automatically archived from the active forums. Because the vast majority of posts are now in one place, this archive is considered legacy. You should use the SEARCH feature OR choose your topic and select date tabs within the forum you choose.
Re: turning off service light on dashboard[850/93] posted by Y.Inouye on
Friday, 19 February 1999, at 9:28 a.m.
Well. I found out about this on this brickboard in the past.
I guess it is my turn to tell you how to do it.
There are two diagnostic units(it says A and B on the cover)
located adjacent to washer reservoir under the hood.
Turn on the ignition and open the module A and insert the flylead
into socket 7. Press the button on the diagnostic unit 4 times,
briefly but firmly. Then the LED illuminates and stays illuminated,
and the system is ready to accept manual code input.
A code number for resetting the service reminder light is 1-5-1.
To do this, press the test button once and release it.
And LED illuminates again. then press 5 times and wait for the
LED to illuminate. Press the button once and LED should
flashes several times in succession and the reminder should have
been reset. Switch off the ignition and replace the flylead in its
holder and close the cover.
--
Yosuke Inouye