Re: Gear position sensor[850/94]

BrickBoard Archives

The files contained in this listing have been automatically archived from the active forums. Because the vast majority of posts are now in one place, this archive is considered legacy. You should use the SEARCH feature OR choose your topic and select date tabs within the forum you choose.

Re: Gear position sensor[850/94] posted by Tony Giverin on
Thursday, 8 April 1999, at 4:38 p.m.

George,
You may be OK...I just happen to have the 850 transmission manual, the manual mentions the tool. The tool has an indentation on it, the mark on the switch is suppose ot align with the mark on the tool. This is done with the gear shift in Nuetral. After alignment, the screws are to be tightened to a torque of 25Nm (37 ft.lbs). Other then that, the instructions are for reinstalling the bracket for the dipstick pipe etc:....have you cleared the DTC's? That may be a clue after-the-fact if you don't get any more codes you could be OK! Hope this helps a bit...:) --
Tony G...'94 850GLT, '82 240DL (mint)

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.