BrickBoard Archives
The files contained in this listing have been automatically archived from the active forums. Because the vast majority of posts are now in one place, this archive is considered legacy. You should use the SEARCH feature OR choose your topic and select date tabs within the forum you choose.
Re: Interior Tailgate Panel Removal[940-960/1993] posted by Alan Carlo on
Monday, 22 June 1998, at 9:45 p.m.
Greg,
There is a plastic piece on the bottom of the interior release recess that pulls off to expose 2 torx screws, T25 I think, on either side. Remove these and the 4 quarter turn fasteners on the bottom of the trim panel. After this the whole trim piece slides upward, along the inside of the glass. There are clips that hold the top on that will break if you try to pull the top out. Support the panel as it is over your head if the tailgate is open. It is good to have a helper to hold the panel. When you free the panel there is a wiring harness for the third brakelight that has to be disconnected. When reassembling the panel, the clips for the top are slid into the slots in the tailgate and the top snaps into place. Also check the rear windshield wiper motor mounting bolts as they often loosen. I put Loctite 242 on mine. Good Luck.
Alan C.